Iso-2S

BUILDING ENVIRONMENTAL MANAGEMENT
SYSTEM FOR OPTIMAL PERFORMANCES

• Easy to Install, Easy to use
• 100% assignable relays and temperature probes
• Simplified Menu
• Easy to Acces Current conditions

• Natural Ventilation Cycles
• Chimney Damper Control
• Drying cycles
• Heater Control
• Test Mode
• Alarms

• 1 to 4 sections of air curtains with 4 blowers for a total of 16 blowers (1 MR8 must be added for systems with 3 or 4 sections)
• 4 temperature probes
• 1 Chimney Actuator with potentiometer
• 1 Heater

• Can control up to 4 zones of curtains with 4 blowers
• 16 outputs for blowers

• Up to 4 temperature probes in the room
• Individual probes can be assigned to a natural output, a heat zone or the chimney

• This feature allows to program opening cycle below target temperature to allow minimal air change in the building in order to get rid of moisture

• This feature allows to program intermittent closing cycles during the hot season to get rid of water accumulation and maintain proper conditions for curtain material

• 1 output for chimney
• Potentiometer feed-back for opening control

• 1 output for heat
• Adjusts start and stop temperatures for heater operation

• To limit access to some functionalities depending on user

• High or Low Temperatures
• Defective chimney operation
• Potentionmeter defects
• Communication with relay failures
• Possible alarm transmission when the signal is sent to Agri Alert system

• Allows simulation of temperature in order to check how system responds in regards with settings

• Allows to copy, download and save the setting for safety or to transfer to other controllers as needed